Flywoo GOKU F405 HD 1-2S 12A AIO V2 Whoop Board

The Flywoo GOKU F405 HD 1-2S 12A AIO ELRS V2 is an all-in-one flight controller and ESC for 1S-2S digital micro whoops and toothpicks, built around an F405 MCU with enough UARTs and a barometer for a full HD video and GPS setup.

Key features

• F405 processor gives more hardware UARTs than the F411 boards common on micro whoops, so HD VTX, a receiver and GPS can all run on dedicated ports.
• On ELRS versions, an onboard serial ExpressLRS receiver over UART, updatable independently of Betaflight firmware releases; the No RX version leaves the port free for an external receiver.
• Integrated barometer (DPS310 or SPL06) and 8MB blackbox flash for altitude hold and post-flight log review.
• Built-in 12A BLHeli_S 4-in-1 ESC supports Oneshot, Multishot and DShot up to DShot600 on 1-2S packs.
• Type-C USB port plus a plug-and-play connector for the DJI O3 air unit keep wiring clean on digital builds.

Specifications

• MCU: STM32F405BGA
• Gyro: ICM42688P or MPU6000 (by variant)
• Barometer: DPS310 / SPL06
• Input voltage: 1-2S LiPo
• Continuous current: 12A
• UARTs: 6
• Mounting pattern: 25.5x25.5mm
• Board size: 30x30mm
• BEC: 5V 2A / 9V 2A
• Weight: 4.9 g
• USB: Type-C
• OSD: none (built for HD digital video)
• Receiver: serial ELRS 2.4GHz (ELRS versions only)
• Firmware targets: Betaflight FLYWOOF405S_AIO, INAV FLYWOOF405HD
• In the box: XT30 power lead, PH2.0 battery lead, DJI O3 cable, capacitor, 4 JST motor sockets, M2 screws, nuts and damping balls; ELRS T-antenna with ELRS versions

A solid base for 75-85mm digital whoops or 2-inch micro freestyle frames that need F405-level processing and altitude hold in a standard whoop footprint.