iFlight Defender 16 Motor

These micro FPV motors are direct OEM replacements designed specifically for the iFlight Defender 16 cinewhoop. Built to handle 2S voltage on sub-250g frames, they are offered in two stator sizes to match your quadcopter's weight and VTX payload. The lighter 1002 variants are typically equipped on analogue or lightweight Walksnail builds, while the larger 1103 stators deliver the extra torque required to carry heavier digital systems like the DJI O3 Air Unit.

Key features

• Direct replacement motors for the custom iFlight Defender 16 frame
• Optimised for 1.6-inch propellers and 2S LiPo power
• Available in specific CW and CCW configurations for exact matched thrust vectors
• Pre-tinned silicone motor wires for straightforward flight controller soldering

Specifications

• Manufacturer: iFlight
• Stator Size: 1002 / 1103 (dependent on variant)
• KV Rating: 14000KV (1002) / 10000KV (1103)
• Input Voltage: 2S
• Shaft Diameter: 1.5mm
• Propeller Mount: T-mount (press-fit 1.5mm)

Always verify your existing drone's stator size and motor direction before ordering. Mixing 1002 and 1103 motors on the same quadcopter will cause uneven thrust distribution and poor flight performance.