GPS Connection Cable 6 Pin for Pixhawk PX4, 30cm

Replacement 6-pin GPS connection cable for linking a GPS/compass module, such as a u-blox M8N-type unit, to the GPS port of a Pixhawk PX4 flight controller. A pinched or torn GPS lead after a hard landing is enough to ground an ArduPilot or PX4 build that relies on position hold, so it is worth keeping a spare in the field box.

Key features

• Plug-in replacement for a damaged or too-short GPS lead on Pixhawk PX4 flight controllers.
• 30 cm length, enough to reach a GPS on a mast or top plate, away from power wiring and ESC noise.
• Suits M8N-type GPS/compass modules with a 6-pin GPS plug.

Before ordering, check both ends of your setup: later Pixhawk-standard boards such as the Pixhawk 4 and 6C use 10-pin JST-GH GPS ports, and GPS makers do not all wire their 6-pin plugs in the same order. Confirm the pin order on your module matches the flight controller before powering up, as swapped power and ground lines can damage the GPS.