Gimbal Vibration Damper Balls 21x17mm Silicone (4 Pieces)

Silicone damper balls that sit between a camera gimbal and a multirotor's airframe, absorbing motor and prop vibration before it reaches the camera. Use them to replace torn or hardened dampers on an existing gimbal mount, or to soft-mount a gimbal plate on a new build.

Key features

• Extra-soft top section absorbs vibration while the firmer silicone body keeps the gimbal located
• Each ball carries roughly 120–180 g, so the set of four supports about 480–720 g in total
• 7 mm inner diameter: check it against the posts or holes on your gimbal plate
• About 1.5 g per ball, so they add almost nothing to the all-up weight
• Colour may vary from pack to pack

Specifications

• Material: Silicone
• Size: 21 × 17 mm
• Inner diameter: 7 mm
• Weight: Approx. 1.5 g each
• Load per ball: 120–180 g
• Pack contents: 4 damper balls

Match the number of dampers to the payload: too many under a light camera leaves them stiff and passes vibration through, while too few under a heavy gimbal lets it sag and wobble. If jello persists, balance your props and check the motor bearings before adding more dampers.