ReadyToSky 10pc 18cm 1.2mm Z-Type Steel Wire Push Rods

Z-type steel wire push rods for connecting a servo arm to an aileron, elevator or rudder control horn on RC planes and foam-board fixed-wing builds.

Key features

• 1.2 mm diameter steel wire, 18 cm long
• Z-bend locks into a horn hole with no clevis or keeper, and cannot slip out once fitted
• Steel wire can be cut down and re-bent with pliers for shorter runs
• Ten rods cover a complete set of control surfaces with spares to hand

Thread the Z-bend into the horn hole before screwing the servo arm or control horn in place, as it cannot be pushed through afterwards. Check that 1.2 mm wire passes your horn holes; open up tight ones slightly with a drill rather than forcing the rod.