HRC40 Anti-Magnetic Stainless Steel ESD Tweezers

Precision stainless steel tweezers for placing and holding small parts during drone builds and electronics repair: SMD components, wire ends, connector pins, and screws and nuts inside tight frames. Choose a straight tip (ESD-13) or a curved tip (ESD-15).

Key features

• Anti-magnetic steel: the tips will not grab steel screws or get tugged by motor magnets, so small hardware stays where you put it.
• Non-corrosive stainless steel: resists rust through regular workshop use.
• HRC40 hardness: hardened steel that resists bending at the tips.
• ESD pattern: intended for work on static-sensitive electronics such as flight controllers, receivers and VTX boards.
• Two tip shapes: straight ESD-13 for general pick-and-place, curved ESD-15 for reaching around components and holding parts at an angle.

When soldering motor wires or battery leads, the curved ESD-15 holds the wire on the pad while keeping your fingers clear of the iron; the straight ESD-13 is easier for setting screws and SMD parts square.